Materials: 2 Vika Amon tables, 7 Vika Curry legs
Description: (This "hack" combines 2 hacks seen here and here at IKEAhackers)
Goal: Remove 1 table leg at inside corner, stabilize with steel plate and organize computer cables rat nest
For desk:
drill, hole saw drill bit
hack-saw
2 "as-is" Vika Amon tables $10 each
7 legs @ 5$ each
1 steel plate ~ $7 at homedepot
14 screws
For cables:
cable management "grommet"
cable ties
wire basket $5 at staples
plastic electric cable organizers to attach basket to table
cable sleeve
PATIENCE!
1. Turn tables upside down
2. Remove inside table leg
3. Position steel plate (lumber connector from Home Depot) longitudinally across seam. Pre-drill holes. (I did 7 on each side)
4. Screw in
5. Flip over
6. Drill out hole for cable grommet
(used a "hole saw bit" to start the hole, then a hack-saw to finish the hole
7. Insert cable grommet
8. Cover bottom of hole with tape to protect wires (for now)
For the cable organizing portion....
1. Mount power strips on the wall
2. Pre-drill 4 holes for wire basket
3. Screw in 2 screws for basket,
4. Fill basket with routers, etc
5. Screw in remaining 2 screws
Voila.
~ gmxray, Boston
0 comments:
Post a Comment