Sleek Stainless Steel Bird Feeder


Materials: Lansa Handle (21 7/8") $9.99, BLANDA BLANK Serving bowl(5"), Drill, Drill bits, screwdriver, pliers $2.99

Description:
Start by drilling drainage holes in the bottom of the bowl.
Then drill a hole in the top just below the rim. In order to use the screws that come with the handle you will have to shorten it with the clipping blades on your pliers.

Thread the screw thru the hole below the rim of the bowl, then the extender piece then into the handle as far as it will go. Mark the screw at the excess point. Disassemble and cut the screw, you may have to make small nips to the tip of the screw to get a clean tip to thread into the handle's hole.


Reassemble if the tilt of the bowl bothers you you can insert a shim below the screw (small piece of wire, plastic etc.) however this will cause a small gap where the horizontal arm meets the bowl. I left my as is.


Insert into the ground, fill with bird seed and enjoy your new best friends as they come to visit!

~ Bambi

1 comments:

Bharathi said...

Hii
Thank you for the informative article. It involves placing a bird feeder into the ground, filling it with bird seed, and then observing and enjoying the presence of birds that come to visit and feed from the feeder. Here is sharing some Microsoft Azure training course journey information may be its helpful to you.
Microsoft Azure Training

Post a Comment

Check out this stream