Geektastic lighting


Materials: Hemma Cord Set, copper wire, blank printed circuit boards

Description:
I wanted to create some lighting for my apartment that would have a very geeky feel. After looking around and finding nothing I wanted I decided to create something from circuit boards.
I purchased blank printed circuit boards from ebay.
I used copper wire and insulated wire. (Local hardware store.)
I hooked this all into a Hemma cord set, well 3 of them for the 3 lights.


I wired the circuit boards together with the copper wiring visible as one square and two triangles. I tried using 5 of them but it was very heavy, the 3/4 seemed to be a good look and weight, they are hung with cup hooks using the hooks that came with the cord set.

I then suspended the Hemma fixture inside with insulated wiring. The piece that screws together allows for a good tight hold and the lights have held up very well for several months.



The circuit boards create a lot of visual interest because they have many different levels of light they let through. The light also creates a great visual on the ceiling above them.

Total cost was around $50 with materials left over.

~ Sara Reller

0 comments:

Post a Comment

Check out this stream